Olen vaeltamassa kolmen ystävän kanssa Oulangan kansallispuiston Karhukierroksella. Näet alla olevista linkeistä vaelluksen kuvauksen ja blogipostaukset.
My new wing project. I’ve got foam parts for two sub250g spec racing wings with 59cm wingspan. Got curious to make one as a long-range wing with submerged electronics and integrated 2S Li-Ion cells. Grabbed electronics nearby and weighted that roughly. It’s going to be light wing. As a racing wing, it has symmetric airfoil […]
Wondering the cost of the final result? Try this calculator. Short url to this page: dima.fi/3dprice
When we fly naked planes or wings, there is no smart flight controller on board, which has some safety functions. All main safety routines depend on your habit. Many of us set an Arm switch function in the radio. A typical solution for Arm switch is just overriding throttle channel by -100 value when the […]
Sometimes I got question why and how did I end up with mirrorless camera. Also as an event photographer many were wondering the significant change in size of the cameras and the lenses. So here I briefly opening what main cameras I had. The reason why I’m talking about main cameras is I also have […]
2020-04-14 Update: New version (V5). I had to raise the height of the band to 15mm, as front stripe slips over in some cases. Slot for the sheet is a lot wider, so you can insert it horizontally to cover the sides of the face. I also added a 5pcs stack model. 2020-04-12 Update: New […]
I love AR Mini wing by Sonic Model. It’s a racing wing with a wingspan of 600mm. With 4S 850mAh battery it weights around 300g. But I was wondering, is it possible to make a smaller and lighter version of it. There was the same project somewhere in the internet las year. But I didn’t […]
Ikea designed new wooden storage box that is perfect for filament spool. A great solution for hiding spools in the living room environment 😉 I had to try to design a spool holder insert for it. Standard spools are 200mm in diameter, so there is good space for silica gel to keep the box dry. […]
Progress blog about creating a small 3d printer with rails, direct extruder and heated bed.
I use airtight cases for 3DJake’s 250g filament spools. But the problem is to know how much filament is left there. So created a kinda smart scale, that tells me the amount in percents. The case is designed to be attached to the top right part of the Prusa i3 printer’s frame by using longer M3 bolts and nuts. […]